@@@
There are two type of dragonloader cards. The first one was a pic based card
(PIC16F84A).
The second one, is just a Fun7 (2x24LC1024) and it is marked as Fun7.
As an alternative, a standard Fun7 can be used as a dragonloader card.
To program the Fun7 based loader card, or a standard Fun7 card
I recomend this way of doing it, since it is the fastest and easiest way of
doing it.
The best thing is that it also works on the serial version of the
programmer, and it takes less than 2 minutes.
Go to the Funcard tab
Give the project a suitable name.
Load the *.dra file as external eeprom.Select EEprom as 2x24LC1024.
Fun7Ldr.hex as Flash (this file is normally distributed with the .dra file).
Leave (or make sure that) internal ee is unticked.
Press program, and wait about two minutes.
If this fails, it is most probably because the loadercard is read protected,
and therefore needs to be erased.
To do this, tick all three tickboxes for the memory, press erase, and try
again.
Håller på att översätta till SVenska , tänkte att detta kan finnas så länge...
Svara med citat
