Hej,
Blir knäpp på detta: kör newcs , men newcs verkar hänga sig efter ungefär 1-2 timmars fungerande användning med nedanstående info i loggen:
13:11:30 ] [ Newcamd:10001 ] Accepted SID 0106 on Reader 0 (Phoenix_on_USB0) from dummy
[ 13:11:30 ] [ ECM Added] [CAID 0000][Provider 00000000][SID 0106]
[ 13:11:30 ] [ ECM Cache ] Hits 2 Total 176 [CRC F545DF47] - returning -999
[ 13:11:30 ] [ 0B00 ] Ecm Cache Check took: 0s 85us [CRC f545df47]
[ 13:11:30 ] [ Card queue /dev/ttyUSB0 ] ECM added, sid 106, prio 3953
[ 13:11:30 ] [ Card queue /dev/ttyUSB0 ] Ecm run, sid 106, prio 3953, queue len: 1, max len: 1
[ 13:11:30 ] [ ECM Cache ] Hits 2 Total 176 [CRC F545DF47] - returning -999
[ 13:11:30 ] [ 0B00 ] Ecm Cache Check took: 0s 79us [CRC f545df47]
[ 13:11:30 ] [ Serial ] Write on fd 6 (len=5)
[ 13:11:30 ] [ Serial ] Read on fd 6 (len=5 timeout=1874ms)
[ 13:11:30 ] [ Serial ] Read on fd 6 (len=1 timeout=1674ms)
[ 13:11:30 ] [ Serial ] Write on fd 6 (len=79)
[ 13:11:30 ] [ Serial ] Read on fd 6 (len=79 timeout=1874ms)
[ 13:11:30 ] [ Serial ] Read on fd 6 (len=1 timeout=1674ms)
[ 13:11:30 ] [ Serial ] Read on fd 6 (len=1 timeout=1674ms)
[ 13:11:30 ] [ Serial ] Write on fd 6 (len=5)
[ 13:11:30 ] [ Serial ] Read on fd 6 (len=5 timeout=1874ms)
[ 13:11:30 ] [ Serial ] Read on fd 6 (len=1 timeout=1674ms)
[ 13:11:30 ] [ Serial ] Read on fd 6 (len=4 timeout=1674ms)
[ 13:11:30 ] [ Serial ] Read on fd 6 (len=1 timeout=1674ms)
[ 13:11:30 ] [ Serial ] Read on fd 6 (len=1 timeout=1674ms)
[ 13:11:30 ] [ Conax ] Viewing status: 0000
[ 13:11:30 ] [ 0B00 ] Card ECM took: 0s 205700us
[ 13:11:30 ] [ SID ] Updating SID 0106 for Reader 0 (Phoenix_on_USB0) bad - SO is: 0
Jag har ett phoenix adteknik (USB) kopplat till ubuntun. har tom kopplat det via en extern usb hub med separat strömförsörjning så det *borde* inte vara något strul med strömnivåer etc.
jag har testat newcs 1.66 samt 1.62 med exakt samma beteende.
Säg inte att jag skall byta till radegast, kör med www.Cardlink.nl och dom stödjer bara newcs
Kanske ni erfarna vet om det är någon fel i config filen?
Eller tror ni det är hårdvarufel?
min newcs ser ut så här
<?xml version="1.0"?>
<newCSconfig>
<globals>
</globals>
<readers name="Phoenix_on_USB0">
<device>
<name>Phoenix_on_USB0</name>
<type>phoenix</type>
<mhz>358</mhz>
<node>/dev/ttyUSB0</node>
<infinity_number>0</infinity_number>
<slot>0</slot>
<parity>odd</parity>
<reset>normal</reset>
<export>Yes</export>
<enabled>Yes</enabled>
<blocksa>No</blocksa>
<blockua>No</blockua>
<blockga>No</blockga>
<blockC0>Yes</blockC0>
<irdetomode>0</irdetomode>
<irdeto-camkey>0000000000000000</irdeto-camkey>
<irdeto-camkey-data>000000000000000000000000000000000000000000000 00000000000000000000000000000000000000000000000000 00000000000000000000000000000000000000000000000000 00000000000000000000000000000000000000000000000000 00000000000000000000000000000000000000000000000000 00000000000</irdeto-camkey-data>
<crypto-special>No</crypto-special>
<ipk>000000000000000000000000000000000000000000000 00000000000000000000000000000000000000000000000000 00000000000000000000000000000000000000000000000000 00000000000000000000000000000000000000000000000000 00000000000000000000000000000000000000000000000000 00000000000</ipk>
<ucpk>00000000000000000000000000000000000000000000 00000000000000000000000000000000000000000000000000 00000000000000000000000000000000000000000000000000 00000000000000000000000000000000000000000000000000 00000000000000000000000000000000000000000000000000 000000000000</ucpk>
<PTShandshake>No</PTShandshake>
<carddetect>yes</carddetect>
<newcamd_port>10099</newcamd_port>
<autosid>Yes</autosid>
<Seca-PPV>no</Seca-PPV>
<pincode>0000</pincode>
<protectedsid>
<id>0000</id><id>0001</id><id>0002</id>
</protectedsid>
<sid>
<allow>
<id>0000</id><id>0001</id><id>0002</id>
</allow>
<deny>
<id>0000</id><id>0001</id><id>0002</id>
</deny>
</sid>
<priority>round</priority>
</device>
</readers>
<cache>
<emm>20</emm>
<ecm>-1</ecm>
</cache>
<httpd>
<server>
<port>8080</port>
<enabled>yes</enabled>
</server>
<user>
<!-- valid value for userfile are:
Any username you'd like - Used for browser to logon (its case sensitive). -->
<name>newcs</name>
<!-- valid value for password are:
Any password you'd like - Used for browser to logon (its case sensitive). -->
<password>newcs</password>
<!-- valid value for accesslevel are:
admin, stats - Define what rights the user has in the web-console -->
<accesslevel>admin</accesslevel>
</user>
</httpd>
<debug>
<password>NewCSpwd</password>
<mode>simple</mode>
<level>normal</level>
<type>init</type>
<output>console,tcp,file</output>
<console_options>normal,init</console_options>
<logfile>/var/log/newcs.log</logfile>
<file_options>spam,all</file_options>
<udp_host>1**************</udp_host>
<udp_port>1000</udp_port>
<udp_options>normal,init</udp_options>
<!-- valid value for tcp_port are:
0,65535 - Which port to listen for incomming tcp connections. -->
<!-- <tcp_port>1001</tcp_port> -->
<tcp_port>14099</tcp_port>
<tcp_options>normal,init</tcp_options>
</debug>
<newcamdserver>
<enabled>Yes</enabled>
<name>cardserver</name>
<deskey>01 02 03 04 05 06 07 08 09 10 11 12 13 14</deskey>
<user>
<name>dummy</name>
<password>dummy</password>
<au>on</au>
<sidoverride>off</sidoverride>
<readers>
<allow>Phoenix_on_USB0</allow>
</readers>
<spider>No</spider>
<cardlevel>1</cardlevel>
</user>
<user>
<name>kalle</name>
<password>kalle</password>
<au>on</au>
<sidoverride>off</sidoverride>
<readers>
<allow>Phoenix_on_USB0</allow>
</readers>
<spider>No</spider>
<cardlevel>1</cardlevel>
</user>
</newcamdserver>
<radegastserver>
<enabled>yes</enabled>
<port>16099</port>
<allow>
<hostname>all</hostname>
</allow>
</radegastserver>
</newCSconfig>
Svara med citat
