Citat Ursprungligen postat av espancor Visa inlägg
Kan det vara så at jag måste andvända mig av MAC-filtrering?
Du kan välja att filtrera bort eller tillåta de du har i listan. Har du det senare alternativet valt o en tom lista så kommer inget kunna ansluta trådlöst.

Enklast är väl att stänga av mac filtret? Antar det är så du har nu?
jag använder dock mac filtrering, o det funkar bra.

Ser du inte router 2 i router1 alls?
kanske skulle göra en reset på båda routrarna o börja om från "scratch" om du inte gjort det?

My setup using V24 buildsredhawk
==Instructions== added 05/29/08 - Security added 06/06/08
A very simple step-by-step instruction to connect a Router running DD-WRT V24 firmware in Client Bridge Mode.
Confirmed working on V24-Final V24-SP1 V24 Pre-SP2

To enable Bridge-Mode between two Routers, the Primary router has to be in AP mode. The Secondary router running DD-WRT as Client Bridged

  1. Do a hard reset (30/30/30) on Client (DD-WRT) Router
  2. Connect to the secondary router via wired LAN port
  3. Open the Wireless -> Basic Settings tab

    • Wireless Mode : Client Bridge
    • Wireless Network Mode : Match Primary Router
    • Wireless Network Name(SSID) : Match Primary Router
    • Wireless Channel : Match Primary Router
    • Wireless SSID Broadcast : Enable
    • Network Configuration : Bridged
    • Save Settings

  4. Open the Wireless-> Wireless Security tab

    • Set your Encryption to either WEP or WPA-Personal

      • Note - Don't use WPA2 for Client Bridge mode

    • If WPA is chosen - use only TKIP or AES...not TKIP+AES

      • Note - the Primary router can be running WPA TKIP+AES
      • Note - 07/15/08 - TKIP + AES is now working on the Client Bridge.- redhawk

    • Enter your encryption key to match the Primary router
    • Save Settings

  5. Open the Setup -> Basic Setup tab

    • Connection Type will be: Disabled
    • Set STP for Disabled (Enabled sometimes can cause connection problems)
    • IP Address : 192.168.1.2 (Assuming Primary Router IP is 192.168.1.1)
    • Mask : 255.255.255.0
    • Gateway: 192.168.1.1 (again assuming Primary Router IP is 192.168.1.1)
    • Assign WAN Port to Switch : Checked or Unchecked - your choice
    • Save Settings

  6. Open the Security -> Firewall tab

    • You MUST Uncheck all boxes except "Filter Multicast" in "Block WAN Requests" before the next step
    • Disable SP1 firewall
    • Save Settings

  7. Open the Administration tab

    • APPLY Settings
    • Click "Reboot" button