AZBOXs egen bruksanvisning:
n order to install AZtrino HD over official Firmware please follow the steps below.
1 Download AZtrino HD software package which contains patch.bin and AZtrino.bin file inside.
2 Copy patch.bin file to your USB Memory stick (FAT32 formatted)
3 Put the USB Stick into AZBox device and start the updating procedure trough Settings menu or by
turning off and then turning on your AZBox.
4 When initial software is installed, your AZBox will displayed IP address. (Note: for Ultra model, you
have to note the IP address from the Settings menu or from your router, as it doesn’t have display).
5 Run AZtrino Loader 1.1 (which You downloaded from www.azbox.com) and enter the IP address
(which was shown before) int the IP address field of AZtrino Loader 1.1. Press button Upload.
6 Once Upload button is pressed, AZtrino Loader will ask you to specify which file you want to be
loaded. Please, select AZtrino.bin file from AZtrino HD package (which You downloaded from www.
azbox.com)
7 After this flashing procedure starts, please wait until AZtrino Loader confirm you that performing
operations are finished.
8 When you get the confirmation message from AZtrino Loader, please remove the USB memory stick
from your AZBox.
That’s all!

Funkar det inte, byt pinne.