Min DM500HD har fått fnatt och står bara och blinkar rött.
Kommer bara åt den via telnet och via dmesg så loopas följande:

Kod:
[4294731.693000] set current avs auto aspect to 4:3
[4294731.693000] disable wss on display 0
[4294731.694000] set wss 8 on display 1
[4294731.694000] set sb to 3(2)
[4294731.695000] set current avs auto aspect to 4:3
[4294731.696000] disable wss on display 0
[4294731.696000] set wss 8 on display 1
[4294731.696000] set sb to 3(2)
[4294731.698000] disable wss on display 0
[4294731.699000] set wss 8 on display 1
[4294731.700000] set input to 0
[4294731.700000] set fb to 2(0)
[4294731.701000] set current avs auto aspect to 4:3
[4294731.701000] disable wss on display 0
[4294731.702000] set wss 8 on display 1
[4294731.702000] set sb to 3(2)
[4294731.705000] set ac3 to downmix
[4294731.896000] bcmfb: creating surface with pixel format 0x07e48888 (BPXL_eA8_                                                                             R8_G8_B8)
[4294731.904000] bcmfb: disable manual blit
[4294732.301000] VIDEO0: set blank to 0
[4294732.302000] sync is off so we enable it
[4294732.302000] playback!
[4294732.303000] total video delay: 0 (0 ms)
[4294732.311000] VIDEO0: start decode
[4294732.314000] flush video decoder
[4294732.476000] VIDEO0: set blank to 0
[4294732.477000] VIDEO0: stop decode
[4294732.478000] VIDEO0: set blank to 0
[4294732.478000] no decoder left in sync handling so disable xpt_sync
[4294732.983000] bcmfb: enable manual blit
[4294733.013000] bcmfb: creating surface with pixel format 0x07e48888 (BPXL_eA8_                                                                             R8_G8_B8)
[4294733.331000] bcm4506 channel 0 is in normale mode now
[4294736.334000] bcm4506 channel 0 is sleeping now
[4294738.254000] bcmfb: creating surface with pixel format 0x07e48888 (BPXL_eA8_
Kör med LT image 6½ sp 4 eller vad den nu heter. Näst senaste releasen.

Någon som har en ide om hur man kan lösa detta?