hur installerar man newcamd i en dm 500-T?

[calux]

Hur installerar man newcamd i en dreambox dm 500-T?
Om man har camd 3.780 installerad behöver man då avinstallera den, och i såfall hur?
Tacksam för svar.

//Calux :cry:

[deas]

Vilken image använder du?

[calux]

dm500_cvs24082005_Leatherface

[deas]

Finns inte Newcamd redan med där?

[calux]

Nej, verkar inte så.

[deas]

Installation:

Copy newcamd.conf to /var/tuxbox/config (dbox2/Dreambox) or /etc (i386).
Copy lib/libcrypto.so.0.9.7 to /var/lib directory
Check the config file and alter it for your needs.
Copy keylist, rsakeylist, ppua, tpscrypt, priority, mappings, nagra*.bin to
/var/scce
Enter keys into the keyfiles.
Install control word driver, avia_gt_proc.o (dbox2) or DVB-S driver with
changed root file (i386). Dreambox has control word driver included in
dream.o from Release 1.07. 1.07.2 uses api2 ca0 device in /dev/ca0, dream.o
from 1.07.3 and up use api3 ca0 device in /dev/dvb/card0/ca0.
dbox2 can also use ca1 device, no avia_gt_proc.o is needed in this case.

With CW_OUTPUT_MODE = 16 newcamd will write the descrambled control words to
/proc/bus/gtx (dbox2), 16 bytes with each write, first 8 byte odd control
word, then 8 byte even control word. With CW_OUTPUT_MODE = 4096 newcamd writes
4096 bytes to /proc/bus/gtx, just like the very first camds did.
On I386 newcamd or BOX_TYPE = DREAMBOX this parameter is ignored, because
control words are written to the ca0 device.

dbox2 users should deactivate hardware section filtering on API3 drivers, for
some reason, which illudes me, the demuxer keeps crashing from time to time
when using newcamd.

[calux]

tackar, nu har jag fått igång newcamd + cardserver mellan två dM 500-T.

//Calux

[deas]

Trevligt!